Room / building requirement study
Ajmi reviews lighting, climate, curtains, scenes, sensors, room panels and guest/user workflow.
Building Automation Integration
Building automation integration for connected facility operations, room control, monitoring and smart technical management.
Real service scope
Building automation integration scope
AJMI coordinates sensors, controllers, gateways and supervisory interfaces for monitored facility operations, with clear ownership between automation, electrical, mechanical, network and third-party systems.
Control sequences must match real facility operation
Points lists, alarm priorities, schedules, trends and operator permissions are agreed before programming. Representative zones are tested against approved sequences instead of relying only on dashboard graphics.
Control-point and interface schedule reviewController, gateway and network architecture coordinationAlarm, schedule, trend and permission configurationSequence testing, operator training and as-built records
Work modules
Service capability modules with field execution
Each module below represents a practical work area Ajmi can handle during planning, installation, commissioning or support.
Controller and protocol planning
Suitable controllers, gateways, panels, relays, sensors and communication protocols are selected by project scope.
Smart panel setup
Room panels, wall switches, mobile control, dashboard or guest interface are configured and tested.
Lighting, climate and scene integration
Lighting scenes, AC interface, curtains, occupancy and comfort controls are integrated where supported.
Testing and user training
Scene response, device status, control logic and user access are verified before handover.
Expansion and maintenance
Ajmi supports future automation expansion, device replacement, troubleshooting and AMC.
Technical system drawing
Automation and smart room control architecture drawing
This drawing shows the real system connectivity behind the service, including source flow, central equipment, network path, endpoint options, testing, support and long-term operation.
Delivery method
How AJMI delivers building automation integration
01
Systems & Point Survey
Mechanical equipment, control panels, sensors, meters, protocols, BMS points and existing sequences are inventoried.
02
Control Sequence Design
Controllers, gateways, networks, dashboards, alarms, schedules and approved integration sequences are defined.
03
Panel & Gateway Integration
Controllers, sensors and gateways are installed or interfaced, then programmed according to the approved points and sequences.
04
Functional Performance Test
Commands, feedback, schedules, alarms, trends and manual overrides are witnessed and recorded before operator handover.
Remote BMS Review
Dashboards, alarms, trends, schedules and controller communications can be reviewed remotely through approved access.
On-site Controls Work
Sensors, actuators, panels, field buses and equipment interfaces require physical inspection and testing.
Automation AMC
AMC can include controller backups, sequence review, calibration coordination, firmware planning and alarm analysis.
Need this service for your project?
Send your requirement and Ajmi will review the suitable technical direction.