Fire alarm site survey
Ajmi reviews building zones, evacuation areas, panel locations, cable routes, interface points and authority or project requirements.
Fire Alarm Integration Support
Fire alarm integration support with related technical systems, monitoring interfaces and facility communication workflows.
Real service scope
Fire-alarm interface coordination by AJMI
AJMI coordinates approved interfaces between the fire-alarm system and connected PA, access-control, building-management, IPTV or monitoring systems without changing the authority of the life-safety system.
Cause-and-effect actions must be approved and witnessed
Input and output points, cable routes, isolation, event priorities and reset behaviour are documented. Interface tests are performed with the responsible fire-alarm party and recorded for handover.
Approved cause-and-effect matrix reviewInterface point, cable and responsibility coordinationAlarm, release, message and reset-behaviour checksWitnessed integration test and signed interface record
Work modules
Service capability modules with field execution
Each module below represents practical fire alarm integration work Ajmi can handle during planning, installation, commissioning or support.
Panel and device coordination
Control panels, detectors, manual call points, sounder-strobes, repeaters and integration interfaces are coordinated according to scope.
Low-current cabling and interface readiness
Cabling paths, conduit readiness, termination points, network links and interface wiring are organized for clean commissioning.
Testing and commissioning
Zone response, alarm indication, notification appliances, repeater panels, monitoring links and integration signals are tested before handover.
Maintenance and support
Ajmi supports troubleshooting, panel coordination, detector faults, event review, integration checks, preventive service and AMC.
Technical system drawing
Fire alarm integration architecture drawing
This drawing shows the real system connectivity behind the service, including source flow, central equipment, network path, endpoint options, testing, support and long-term operation.
Delivery method
How AJMI supports an approved fire-alarm interface
01
Panel & Interface Review
The fire panel make, approved cause-and-effect, available relay or protocol points and the receiving system requirements are reviewed.
02
Interface Coordination
AJMI documents the supervised interface, signal direction, network or relay method and responsibilities with the fire-alarm specialist.
03
Approved Connection Work
Only approved gateways, relays, monitored inputs or software interfaces within AJMI's scope are connected and labelled.
04
Witnessed Cause-and-Effect Test
Interface events, alarms, resets and receiving-system actions are witnessed with the authorised fire contractor and recorded.
Remote Document & Log Review
Approved drawings, interface logs and receiving-system events can be reviewed remotely; life-safety devices are not remotely altered.
Coordinated On-site Test
Physical interface testing is carried out on site with the responsible fire-alarm specialist and site authority.
Interface Maintenance
Maintenance covers AJMI's approved interface components and records; statutory fire-system maintenance remains with the authorised provider.
Need this service for your project?
Send your requirement and Ajmi will review the suitable technical direction.